Raymarine E66008 Owner's Handbook Manual page 29

All manuals and user guides at all-guides.com
Chapter 2: Installation
Retaining pin
Safety ring
Cap nut
Stem
Hull nut
Backing
block
Hull
Fairing
Figure 2-7:
Dry Fit for Fairing
WARNING:
If a fairing is used, the anti-rotation bolt must be installed to
prevent the fairing from rotating when the boat is underway.
1. Dry fit the transducer to locate the hole for the anti-rotation bolt.
2. Thread the transducer cable through the large hole in the fairing
Note:
more than 1/64" (0.5mm) inside the fairing, you may carefully file or
sand the fairing flush with the transducer.
WARNING:
Always wear safety goggles and a dust mask.
3. Attach the drill bit to your drill appropriate for your fairing:
Seating
and through the mounting hole in the hull. Seat the transducer
firmly in the recess in the fairing.
The transducer must be flush with the fairing. If it is recessed
Fairing Used with Transducer
E26017 E66035
E66023 E66020, E66029
E66025 E66024
E66034 E66033
E66045 E66043
Marine
sealant
D5566-1
Drill Size
"
3/8 (10mm)
"
3/8 (10mm)
"
1/2 (13mm)
"
1/2 (13mm)
"
3/8 (10mm)
23