Raymarine E66008 Owner's Handbook Manual page 26

20
Band saw table
Deadrise
angle
Bow end for
installation
on port side
Figure 2-5:
CAUTION:
The arrow on the fairing always points forward towards the bow.
Be sure to orient the fairing on the band saw so the angle cut
matches the intended side of the hull.
3. Place the fairing on the table so the cutting guide rests against the
WARNING:
Always wear safety goggles and a dust mask when drilling.
4. Recheck steps 1 through 3, then cut the fairing.
5. Shape the fairing to the hull as precisely as possible with a rasp or
Antifouling Paint
Marine growth can accumulate rapidly on the transducer's surface,
reducing performance in weeks. Surfaces exposed to salt water must
be coated with antifouling paint.
All manuals and user guides at all-guides.com
Cutting the Fairing
fence. The arrow/blunt end will point toward you for installation
on the port side and away from you for installation on the star-
board side of the boat.
power tool.
Transducers for Fishfinders
Cutting guide
Fence
D4860-2