Raymarine E66008 Owner's Handbook Manual page 30

24
4. Slide the transducer's stem with the fairing in place into the
5. While holding the assembly in place and using the bolt hole in the
6. Remove the assembly and cable from the mounting hole.
7. Sand and clean the area around the hole, inside and outside, to
Figure 2-8:
Seating
1. Remove the transducer from the fairing, if used.
2. Stainless steel transducer in metal hull - Slide the appropriate
WARNING:
To prevent electrolytic corrosion, never allow direct contact
between a stainless steel transducer and a metal hull.
All manuals and user guides at all-guides.com
mounting hole. Be sure the triangular recess in the fairing is point-
ing forward toward the bow.
fairing as your guide, drill a hole through the hull for the anti-rota-
tion bolt.
ensure that the sealant will adhere properly to the hull.
Metal hull - Remove any burrs around both holes with a file and
sandpaper.
Anti-rotation
bolt
Nut and
washer
Triangular plug
with curved surface
facing outward
Using a Fairing and Backing Block
size isolation sleeve over the cable and onto the stem of the trans-
ducer as far down as possible (see Figure 2-3 ). Be sure the top of
the isolation sleeve will be below the top of the backing block to
prevent the sleeving from interfering with tightening the hull nut.
Transducers for Fishfinders
⇐
BOW
Backing
block
D5565-1
Fairing