Raymarine E66008 Owner's Handbook Manual page 14

8
• If the propeller can be turned to steer the boat, allow at least 2" (50
Figure 1-1:
• Do Not mount the transducer behind any hull fittings, intakes or
• The bracket has a quick-release mechanism, shown Figure 1-2 .
All manuals and user guides at all-guides.com
mm) beyond the swing radius of the propeller. This will prevent
the propeller from damaging the transducer when it is turned.
Transom Mount Transducer Location
other parts extending from the hull that may cause turbulence or
air bubbles.
This allows the transducer to flip up if it hits any debris or the bot-
tom. Allow enough clearance above the transducer for it to swing
upwards completely – this is about 10" (254 mm), measured from
the bottom of the transom.
Transducers for Fishfinders
Approximately 18 in (457 mm) clearance
Be sure to allow at
least 2 in (50 mm)
beyond the swing radius
of the propeller
D4871-2