Installation; Installing The Transom Mount Transducer; Preparation - Raymarine E66008 Owner's Handbook Manual

All manuals and user guides at all-guides.com
Chapter 2: Installation
Chapter 2: Installation
This chapter gives details on how to install your transducer.
Instructions are divided into the following sections:
• Transom Mount Transducers - recommended for personal
• Thru-Hull Transducers - recommended for boats with straight-
• In-Hull transducers- recommended for fiberglass hulls, espe-

2.1 Installing the Transom Mount Transducer

Preparation

Transducer Mounting Bracket
When installed, the lower surface of the transducer should tilt down
toward the rear at a slight angle (2° to 5°). The mounting bracket
includes a wedge; depending on the angle of the transom on your
boat, you may need to install this wedge to get the correct transducer
angle.
1. To attach the transducer to the bracket, insert the transducer
Figure 2-1:
watercraft and powerboats with outboard, inboard-outboard and
jet drives.
shaft inboard engines.
cially in high speed power boats and racing sailboats.
mounting lugs into the slot in the bracket as shown in Figure 2-1 .
Correct
Attach the two parts
Lower the transducer and
snap in the release clip
Fitting the Transducer to the Bracket
15
Incorrect
Bracket is installed
upside down
D4874-2