Internal Power Harness Service Assembly - Fitting - Dyson PH01 Service Instructions Manual

Repair notes

Internal Power Harness Service Assembly - fitting

95 Locate the gasket into the hole in the Lower body. Ensure it is centered and there are no folds.
94 Feed the new Power Harness
through the right handside of the
Lower Body Service assembly.
96 Locate the Harness through the
opening in the top of the holder.
54
97 Pull the Jack into the holder until it
locks and is flush with the edge as
shown.
98 Seat the front of the holder into the
gasket.
55