Advertisement
INSTALLATION
TO REMOVE EXISTING TOILET
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
Remove the old gasket from the floor
and the closet flange with a putty knife.
Remove the old T-bolts and discard
them.
NOTICE:
If the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
Install two new 8mm (5/16") diameter
T-bolts into the closet flange.
NOTICE:
Do not use white cement or
high lime content cements to install
this toilet. The expansion of cement
due to a rise in temperature may make
the toilet crack or cause damage.
Kohler is not responsible for any
damage caused by installation with the
use of cement.
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install the supply shut-off valve so it is
203mm (8 ) above the finished floor
"
line. The supply shut-off valve must be
127mm
(5")
to the left of the closet
flange centerline.
The supply shut-off valve outlet should
extend 83mm (3-1/4 ) from the finished
"
wall.
TO INSTALL NEW BOWL
Set the bowl upside down on some
padding. Firmly press the toilet gasket
onto the
bowl
outlet.
NOTE 1:
Wax ring type toilet gasket
should not be installed at temperatures
less than 21 .
NOTE 2:
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
1033003-T01-N
Closet Flange
Fig.#2
2
T-bolts
T
Fig.#3
3
83mm
Supply Shut-Off Valve
127mm
127mm
305mm
Fig.#4
4
Toilet Outlet
Toilet Gasket
Closet Flange
Fig.#5
5
(
)
Closet Flange
Closet Flange
Centerline
T-Bolt
T
T
8mm
T
203 mm
127mm
83 mm
21
Advertisement
