Advertisement
If you temporarily plugged the closet
flange with a rag, remove the rag at
this time and ensure that the drain pipe
is clear and free of debris.
Carefully align and lower the
the closet flange and T-bolts. Apply full
body weight to the
bowl
seal.
CAUTION: Risk of external
leakage.
Do not lift or rock the
bowl
after placement - a new
toilet gasket must be installed if
you break the watertight seal.
Assemble the bolt cap bases, washer,
and nuts on the exposed T-bolts.
Handtighten the nuts, then tighten
them an additional 1/2-turn.
CAUTION: Risk of personal
injury or product damage.
Overtightening may cause
breakage or chipping of the
vitreous china.
If the T-bolts extend more than 6mm
(1/4") over the top of the nuts, cut off
the excess and file the end. Wipe
away any residue. Install the bolt cap.
TO INSTALL NEW TANK
Make sure the three tank bolts extend
completely through the holes in the
gasket. Set the tank onto the bowl,
using the tank bolts as a guide. Center
the gasket on the inlet of the bowl.
Assemble the washer and brass nuts
onto the bolts.
Alternately tighten the three brass nuts
so the top of the tank and the top of
the bowl are both level. Be sure the
brass nuts are tight enough to achieve
a wate tight seal.
CAUTION: Risk of personal
injury or product damage.
Over tightening may cause
breakage or chipping of the
vitreous china.
TO CONNECT WATER
SUPPLY
* Flexible hose (not provided) are
recommended to connect the supply
line to the fill valve. If you use a rigid
connection(not provided), take care
not to apply side forces to the bottom
of the fill valve. Be sure the rigid
connection must be fit with supply line
completely to prevent damage shank
by forced connection.
1033003-T01-N
bowl
over
rim to set the
Bolt Cap*
Nut
Washer
Bolt Cap Base*
* Shape of the actual gasket may not be the
same as shown, but installation method
remains the same.
*
Supply Shank*
T-Bolt
T
Fig.#6
6
Tank Bolt
Gasket*
*
Washer
Brass Nut
Fig.#7
7
Supply Shut-Off Valve
Fig.#8
8
-4-
T
T
6mm
*
(
(
)
)
Advertisement
