Advertisement
Fasten the snap along "CLOSE"
direction.
Float adjustment instructions: Make
sure the height of surface E is 2-4mm
lower than surface G.
1. Fill valve turns on/off by itself without
toilet being flushed.
2.
Fill
valve continues to run, allowing
water to enter tank.
3. Incorrect water level height.
4. Long or noisy tank fill cycle.
5. Poor flush.
6. Toilet overflows.
7. Toilet does not activate.
1033003-T01-N
Fig.#11d
11d
E
Float
Water Cup
Fig.#11e
11e
A. No slack in flapper chain assembly,
holding flapper off seat.
B. Flush valve flapper ball worn, dirty
or misaligned with flush valve seat;
or seat corroded so flapper will not
seal.
C. Refill tube pushed too far down in
overflow pipe.
A.
Fill
valve seal (located under fill valve
cap) may be cracked or split.
B. Tank water level set above overflow
level.
C. Water leaking past flush ball.
D. Trip lever binding, holding flush ball
open.
A. Valve float cup does not contain
enough water to provide required
ballast.
B. Float height incorrect.
A. Plugged valve inlet or supply line.
A. Water level is too low.
B. Trapway or rim holes are obstructed.
C. Soil pipe or vent is obstructed.
D. Supply shut-off valve not fully open.
E. Low water level in bowl due to refill
tube being plugged or out of overflow
tube.
A. Toilet trapway is obstructed.
B. Soil pipe or vent is obstructed.
A. Chain is not connected to lift rod or
flush valve.
-6-
CLOSE
Screw
E
G 2mm
G
A. Adjust flapper chain assembly for
proper slack.
B. Inspect, clean and, if necessary,
replace flapper ball and/or seat.
C. Attach refill
tube
above the water line.
A. Replace seal.
B.
During fill cycle, hold float under water
a few seconds to allow it to fill with
water ballast. Refer to "Minor
Adjustment of Water Level" for
waterline adjustment.
C. Replace flush ball.
D. Turn trip lever nut clockwise to loosen
until trip lever no longer binds.
A. During fill cycle, hold float under water
a few seconds to allow it to fill with
water ballast.
B. Refer to "Minor Adjustment of Water
Level" for waterline adjustment.
A. Perform Corrective Action 2.A.
A. Adjust
tank
water level.
B. Unclog trapway; clean rim holes.
C. Clear obstruction from soil pipe or
vent.
D. Open supply shut-off valve.
E. Clean or straighten refill tube; attach
refill tube to overflow tube.
A. Use plunger to unclog.
B. Clear obstruction from soil pipe or
vent pipe.
A. Reconnect the chain.
to overflow pipe
Advertisement
