Snap Disc; Door Handle Assembly - Quadra-Fire DISCOVERY-III-C Owner's Manual

C. Snap Disc
Service Part: SRV230-0470
1. Locate the snap disc bracket assembly at the bottom left
rear corner of the appliance.
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the

snap disc.

3. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors.
4. Replace with new snap disc and re-connect to spade
connectors.
5. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 23.1
6. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Snap Disc
Magnet
Figure 23.1
23
D. Door Handle Assembly
NOTE: DO NOT over tighten locking nut; door handle
1. Slide door handle through door.
2. Install additional washer(s) as shown in Figure 23.2.
3. Install key in groove.
4. Align groove in latch cam with key; slide latch cam
5. Install locknut but do not over tighten, the handle needs
6. Install fiber handle (Figure 23.2).
Figure 23.2
Spade
Connectors
7037-804D
needs to move smoothly!
Service Part: SRV7033-071
over shaft
to rotate smoothly.
Door Cross
Latch Cam Section
Locknut
Spacing
Washers
Door Handle Shaft
Square Key
Fiber Handle
07/21