Decorative Side Panel - Quadra-Fire DISCOVERY-III-C Owner's Manual

F. Decorative Side Panel
Left Side Panel Service Part: SRV7037-026
Right Side Panel Service Part: SRV7037-027
Tile Frame Service Part: SRV7033-324
Frame Blank Service Part: SRV7033-346
Your appliance ships with two different side options, one
is a solid side panel (Figure 25.1) and tile side panel
(Figure 25.2). There are two of each and no left or right
side, these can be changed at anytime.
Figure 25.1
The appliances are being shipped with a solid side panel
securing clip on both sides. Please remove and discard
pins prior to use (Figures 25.3).
Figure 25.3
Solid Side Panel Removal
• Remove solid panel from side by lifting up and pulling
away from appliance (use a flat tool to pry from bottom
if needed) (Figure 25.4).
NOTE: 300°F high temp paint can be use to repaint the
solid side panel only! DO NOT use on the rest of
appliance this requires 1200°F high temp paint.
25
Figure 25.2
Securing
Clip
Figure 25.4
Tile Panel Installation
1. Remove tile frame from side by lifting up and pulling
away from appliance (Figure 25.4 reference solid
side panel removal).
2. Stack non-combustible material tiles in tile frame as
shown in Figure 25.2.
Fire Risk.
Use only noncombustible materials as a
decorative tile.
3. Reattach tile frame (Figure 25.5).
Figure 25.5
Tile Dimensional Requirements:
Max Thickness: 5/16"
Max Length/Width: 11-7/8" square
Min Length/Width: 11-11/16" square
7037-804D
WARNING
3
07/21