Installation fundamentals
Important:
The USB port on the back panel of the Ethernet Routing Switch 5600 Series models is not
enabled.
Placement options and cables
The following sections describe the available placement option and requirements, as well as
cables for the Ethernet Routing Switch 5000 Series switch.
Environmental requirements
This module describes the environmental requirements for the Ethernet Routing switches.
The Ethernet Routing switches must be properly mounted in a dry, well-ventilated area with
adequate power available for optimum operation. See the environmental specifications in the
job aid for
Placement options
You can mount 5000 Series switches on a flat surface such as a table or shelf, or in a rack.
Choose the mounting option that best suits your location. The following sections describe the
options.
Navigation
•
Switch installation on a table or shelf
•
Switch installation on the wall
•
Switch installation in an equipment rack, front mount option
•
Switch installation in an equipment rack, rear mount option
Choose the mounting solution that suits your requirements and site.
Switch installation on a table or shelf
You can mount 5000 Series switch on a flat surface such as a table or shelf. See
a table or shelf
The surface, whether a shelf or table, must be able to support the combined weight of the
switch and attached cables; between 21 and 33 pounds (9.5 to 15 kilograms) for a 5600 Series
switch.
16
Installing Avaya Ethernet Routing Switch 5000 Series
Verifying environment suitability
on page 46, to install a single unit on a table or shelf.
Comments? infodev@avaya.com
on page 43.
on page 16
on page 17
on page 17
on page 17
Mounting on
December 2013