3. Disassembly and Reassembly
3-17 Replacing the HOT SURFACE IGNITOR (HSI) of the BURNER BROIL,
NOZZLE Broil-Burner, and HOLDER Broil-BURNER
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing . Check all gas lines and fittings for leaks before operating
the range . Replace all panels before operating range . Failure to do so can result in death or personal
injury from explosion, fire, or asphyxiation .
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be
present, and you can cut yourself if you are not careful .
Parts
Hot Surface
Ignitor (HSI)
Nozzle
Broil-Burner
Holder Broil-
Burner
This document can not be used without Samsung's authorization.
Explanation Photo
Remove the gas nozzle
29
Explanation
1. To replace the HSI of the burner
broil, Remove 2 screws assembled
to HSI
1. To replace the nozzle broil-burner,
Remove the gas nozzle with a
9/32-inch socket wrench .
1. To remove the holder-broil burner,
Remove 2 screws supporting the
holder-broil burner to the rear of
the oven .
2. When the service is complete,
reverse the order to install burner
broil, HSI, Nozzle and Holder broil
burner .
NOTE: The oven burner flames can
be adjusted by loosening the
locking screw and opening or
closing the air shutter at the
base of the oven burner .