Replacing The Burner Broil - Samsung NX583G0VBSR Service Manual

3. Disassembly and Reassembly

3-16 Replacing the Burner Broil

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be
present, and you can cut yourself if you are not careful .
Parts
CONNECTOR
BRACKET
HSI-WIRE
Burner Broil
BROIL-SPREADER
This document can not be used without Samsung's authorization.
Explanation Photo
BRACKET
BURNER BROIL
1. Turn off the electrical supply going
to the range .
2. Shut off the gas shut-off valve in
the gas supply line to the range .
3. Open the oven door and remove
the racks from inside the oven .
4. Remove Cover-back main wire to
the rear of the oven .
5. Disconnect the wires or the
connector of the HSI . (Identify and
mark the two wires going to HSI .)
6. Remove 1 screw of bracket HSI-
wire
7. Remove 4 screws of bracket-broil
spreader to top of oven .
8. Support the burner-broil with one
hand, remove 2 screw supporting
the burner-broil to the front and the
rear of the oven .
9. Pull the upper ASSY-BURNER
BROIL SPREADER to disconnect it
from the holder nozzle-broil on the
rear wall of the oven .
10. Carefully remove ASSY-BURNER
BROIL SPREADER .
11. Separate the burner broil and
bracket-broil spreader .
28
Explanation