Table of Contents
Advertisement
Inspection and spares
5.5
Redirecting the plume terminal discharge
The plume deflector can be adjusted to redirect the flue discharge.
NOTICE:
FLUE DISCHARGE
▶ The Plume terminal outlet position must follow the conditions stated
in figure 52. When redirecting the flue discharge the outlet must be at
least 1,500mm from and angle at least 45 ° away from any opening in
the direction of the discharge, as shown. This is to prevent
combustion products from entering the building.
±45°
2
3
Fig. 52 Plume direction conditions
[1]
Opening in the building i.e. air brick, window.
[2]
Direction of the flue products, must be more than 45° from the
wall or structure.
[3]
Plume terminal.
[4]
At least 1,500mm from any opening in the building.
22
4
1
6
Inspection and spares
6.1
Inspection and maintenance
▶ An annual visual check of the flue system including the plume
management kit (if fitted) must be carried out in addition to the
checks stated in the appliance Installation and maintenance
Instructions.
NOTICE:
Painting
▶ Do not paint the plume management kit.
6.2
Spare parts
Replacement wall mounted horizontal flue components.
Terminal outlet
assembly
8 716 11 209 0
Wall seal - outer
8 716 111 212 0
Air sample point plug -
Flue turret
8 716 11 253 0
Air sample point plug -
Flue turret (silver)
8 7137 709 576
Connection joint seal -
102mm
8 716 111 673 0
Flue screw pack
8 713 406 039 0
Table 7 Spare parts list
Greenstar Condensfit II – 6 720 874 391 (2019/04)
Wall seal - inner
8 716 11 211 0
Collar - Flue turret
8 716 11 254 0
Flue gas sample point
cap & seal - Flue turret
8 716 11 252 0
Flue gas sample point
cap & seal - Flue turret
(silver)
8 737 709 577
Connection joint seal -
62mm
8 711 004 367 0
Advertisement
Table of Contents
