Table of Contents
Advertisement
Plume management system
5
Plume management system
5.1
Plume management product information
Plume management kit - 7 716 191 086
Fig. 28 60mm plume management kit components
[1]
Terminal elbow
[2]
Extension 500mm
[3]
Outlet assembly
[4]
Clamp pack-
60mm plume management accessories
1 1,000mm extension with support clamp
2 90° elbow
3 45° elbow (set of 2)
4 Terminal guard
5 Support bracket
Table 4
Fig. 29 Plume management accessories
14
5.2
NOTICE:
Plume management length:
▶ The plume management length must be a minimum of 500mm and
must not exceed the maximum straight length for a horizontal Ø 60/
100mm flue with a 60mm plume management system as stated in
the relevant appliance Installation and maintenance instructions.
1
Horizontal plume management runs
2
▶ The initial horizontal run from the terminal elbow must have a
minimum 10° fall back, (stop tabs in the elbow prevent less than 10°)
to the appliance for proper disposal of condensate.
▶ Any further horizontal runs after an elbow can be 3°.
3
4
Minimum plume management length:
The minimum distance of 500mm must be maintained between air inlet
and exhaust.
▶ Do not terminate the plume management inside the terminal
exclusion zone (shaded area) shown in figure 30.
7 716 191 087
7 716 191 088
7 716 191 089
7 716 191 176
8 716 111 275 0
1
2
3
Fig. 30 Terminal exclusion zone
NOTICE:
Cutting the 500mm pipe
4
If the 500mm plume management pipe kit is cut, an additional elbow will
be required to join the pipe work.
▶ The Plume management extension kit contains the components
5
required for such a configuration.
0010013547-001
Plume management options and measurements
WARNING:
m
0 m
5 0
m m
5 0 0
Greenstar Condensfit II – 6 720 874 391 (2019/04)
5 0
0 m
m
±80°
0010013548-001
Advertisement
Table of Contents
