Table of Contents
Advertisement
set to cut more than the maximum cutting time for each
day.
4.3.5.1 To override the schedule
This can be set in the dashboard in the app or with the
keypad on the product:
1.
Push the STOP button.
2.
Push the GO button for 1 second.
3.
Push the OK button.
4.3.6 Spot cutting
Spot cutting function to quickly cut an area
Use the
where the grass has been cut less than in other parts of
the yard. You must manually move the product to the
selected area. This operating mode can only be set in
the app.
Spot cutting means that the product operates in a spiral
pattern in order to cut the grass in the area where it was
started. When this is done, the product automatically
Main area or Secondary area .
switches back to
4.4 To stop the product
1.
Push the STOP button on top of the product.
Note:
When the STOP button is pushed the product
will be idle. The product stops and the cutting motor
stops.
1622 - 001 - 03.03.2021
4.5 To switch off the product
1.
Push the STOP button.
2.
Push the ON/OFF button for 3 seconds.
3.
The product shuts down.
4.
Check that the indicator lamp on the keypad is not
lit.
4.6 To charge the battery
WARNING:
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been stored for a long
period, the battery can be empty and needs to be
charged before starting. In the
product automatically alternates between mowing and
charging.
1.
Push the ON/OFF button to start the product.
2.
Put the product in as far as possible in the
charging station. Make sure that the product and
the charging station is connected. Refer to contact
and charging strips in
Product overview on page 4
4.7 Adjust the cutting height
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied 3 steps. Step 1 is the
lowest height, step 2 is the middle height, and step 3 is
the highest height. The steps 1-3 are marked on the
Only charge the product
Main area mode, the
Operation - 25
Hide quick links:
Advertisement
Table of Contents
