Symptoms - Flymo EasiLife GO Operator's Manual

6.5 Symptoms

If the product does not operate as usual, follow the symptoms table below. Speak to your Flymo service if you cannot
find the cause for the fault.
Symptoms Cause
The product has diffi- The guide wire is not put straight in a line
culty docking. and correct distance from the charging sta-
tion.
The guide wire is not put in the slot in the
charging station plate.
The charging station is not on a level sur-
face.
The product operates The start and stop times for operating are in-
at the wrong time. correct.
The product vibrates. The cutting system is not in balance because
of damaged blades.
The cutting system is not in balance because
of too many blades in the same position.
Different thickness of blades are installed on
the product.
The product oper- The product searches for the charging sta-
ates, but the blade tion, or is moving to the starting point.
disc does not rotate.
The product operates Grass or other object causes a blockage to
for shorter periods the blade disc.
than usual between
The battery is at the end of its life cycle.
charges.
Blunt blades. More energy is necessary
when cutting the grass.
Mowing and charging The battery is at the end of its life cycle.
times are shorter
than usual.
The product is The product has operated the maximum cut-
parked for hours in ting time for the day.
the charging station.
The STOP button has been pushed.
Parking mode is enabled.
The product does not operate if the battery
temperature is too high or too low.
1622 - 001 - 03.03.2021
Action
Do a check of the installation of the charging
To install the charging sta-
station. Refer to
tion on page 17 .
Make sure that the guide wire is put straight
in a line and put in the slot in the charging
station plate. Refer to To install the guide
wire on page 18 .
Put the charging station on a level surface.
To examine where to put the charg-
Refer to
ing station on page 12 .
Change the schedule settings. Refer to
do the Schedule settings on page 20 .
Examine the blades and screws and replace
them if necessary. Refer to Replace the
blades on page 28 .
Do a check that only one blade is attached to
each screw.
Do a check if the blades are of different thick-
ness and replace if necessary.
Usual operation for the product. The blade
disc does not rotate when the product is
searching for the charging station.
Remove and clean the blade disc. Refer to
Clean the product on page 27 .
Replace the battery. Refer to
page 29 .
Replace the blades. Refer to
blades on page 28 .
Replace the battery. Refer to
page 29 .
Usual operation for the product. Refer to
Make an estimate of the necessary operating
time on page 20 .
Enter the PIN code and push the OK button.
Push the GO button.
Change the operating mode. Refer to
ating modes on page 23 .
Make sure that the charging station is put in
an area with protection from the sun.
Troubleshooting - 37
To
Battery on
Replace the
Battery on
Oper-