To Stop The Product; To Set The Product To Off; To Charge The Battery; Adjust The Cutting Height - Flymo EasiLife Operator's Manual

4.3.2 Secondary area
To cut secondary areas the operating mode
area must be selected. In this mode, you must move
the product manually between the main area and the
secondary area. The product cuts for a selected period
of time or until the battery is empty. When the battery
is empty the product stops. Put the product in the
charging station to charge the battery. When the battery
is charged, the product moves out of the charging
station and stops. The product is now prepared to start
operation, but needs confirmation from you first.
Note:
If you want to cut the main area after the battery
is charged, set the product to
you put the product in the charging station.
4.3.3 Park
Park means that the product returns
Operating mode
to the charging station where it remains until a different
operating mode is selected.
4.3.4 Park / Schedule
Park / Schedule means that the product
Operating mode
goes back to the charging station where it stays until the
next schedule. If the product has operated the maximum
cutting time for the day, it will start to operate again the
Make an estimate of the necessary
next day. Refer to
operating time on page 22 .
4.3.5 Override schedule
Override schedule to temporarily override the
Select
schedule settings. You can select to override the
schedule settings for 3 hours. The product cannot be
set to cut more than the maximum cutting time for each
day.
4.3.6 Spot cutting
The Spot cutting function is activated with the GO
button and is useful for quickly mowing an area where
the grass has been mown less than in other parts of
the yard. You must manually move the product to the
selected area.
Spot cutting means that the product mows in a spiral
pattern in order to cut the grass in the area where it was
started. When this is done, the product automatically
Main area or Secondary area .
switches back to

4.4 To stop the product

1. Push the STOP button to make the product and
the cutting motor stop.
1392 - 007 -
Secondary
Main area mode before

4.5 To set the product to OFF

1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds.
3. Make sure that the LED indicator on the keypad is
off to make sure that the product is set to OFF.

4.6 To charge the battery

When the product is new or after long-term storage, the
battery can be empty. Charge the battery before you
Main area mode, the product
start the product. In the
cuts and charges automatically.
1. Push the ON/OFF for 3 seconds button to start the
product.
2. Put the product into the charging station until the
charging plates touch the contact plates.
3. Do a check that the display shows the message
CHARGING to make sure that the product is
connected correctly to the charging station.

4.7 Adjust the cutting height

CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
4.7.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch.
Operation - 29