Table of Contents
Advertisement
Error Responses
When the SMD 101 is unable to execute the command, it returns an error response to the
host. The error response codes and their descriptions are as follows:
E10 Unrecognized command
E12 Invalid port number
E13 Invalid parameter (number is out of
range)
E14 Not valid for this configuration
E17 System timed out
E22 Busy
Using the Command and Response Tables
The
Command and Response Tables
represent variables in the command and response fields. Command and response examples
are shown throughout the tables. The SIS commands are not case sensitive. The ASCII to
HEX conversion table below is for use with the command and response tables.
ASCII to HEX Conversion Table
Space
I
Figure 104.
l
ASCII to Hex Conversion Table
SMD 101 • Remote Communication and Control
E24 Privilege violation
E25 Device is not present
E26 Maximum connections
exceeded
E28 Bad filename or file not found
E30 Hardware failure
E31 Attempt to break port pass-
through when not set
begin on page 120. Symbols used in the tables
•
116
Advertisement
Table of Contents
