Table of Contents
Advertisement
SMD 101 Power Up Procedure
NOTE: Before powering on the SMD 101, ensure that all necessary devices are
Connect the external power supply to a 100 to 240 VAC supply (see
on page 10). The DC power LED lights and the SMD 101 undergoes a self testing
sequence. When connected to a network, the front panel network LED indicator lights green
when the SMD 101 is ready to decode.
Hardware Setup Overview
NOTE: If it is difficult to access the device after installation, configure the network
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
connected properly. Devices do not need to be powered.
settings of the SMD 101 prior to starting (see
If the SMD 101 has been on for configuration, turn it off and disconnect the SMD 101
and all connected devices.
Mount the SMD 101 (see
Mounting the SMD 101
Connect one end of an RJ-45 cable to the rear panel LAN connector on the SMD 101
Rear Panel Features
(see
to the local network.
Connect a compatible output device to the rear panel (see
page 10) and power it on.
Connect a control device to the SMD 101 by one of the following connections:
a.
The front panel config port (see
b.
The rear panel RS-232 port (see
c.
The Ethernet connection. Configure the network settings of the control PC so it is
compatible with the network the SMD 101 is connected to (see
Port
on page 113).
Connect the external power supply output connector to the SMD 101 (see
Features
on page 10), then connect the power supply to a 100 to 240 VAC, 50 Hz
or 60 Hz power source. The SMD 101 powers up automatically and undergoes a self
testing sequence (see the SMD 101 Power Up Procedure, above).
From the control PC, access the user interface of the SMD 101 (see
Web-based User Interface
Select a stream to decode (see
If necessary, set the decoder output for the connected display (see
page 3 and
Video Configuration
Press Play on the software interface (see
the optional remote control (see
the selected stream.
figure 64
on page 134).
on page 10). Connect the other end of the RJ-45 cable
Front Panel Configuration Port
RS-232 Port
on page 111).
on page 15).
Player Page Overview
on page 47).
Player Page Overview
IR Remote Control
on page 110) to begin decoding
SMD 101 • Panels and Cabling
Rear Panel Features
on page 67).
Rear Panel Features
on
on page 112).
LAN (Ethernet)
Rear Panel
Overview of the
on page 22).
Video Output
on
on page 22) or on
14
Advertisement
Table of Contents
