Error Responses
When the SME is unable to execute the command, it returns an error response to the host.
The error response codes and their descriptions are as follows:
– Unrecognized command
E10
– Invalid port number
E12
– Invalid parameter (number is out of range)
E13
– Not valid for this configuration
E14
– Invalid command for signal type
E17
– System timed out
E18
Using the Command and Response Tables
The
Command and Response Tables
represent variables in the command and response fields. Command and response examples
are shown throughout the table. The SIS commands are not case sensitive. The conversion
table below is for use with the command and response table.
Figure 42.
Conversion Table
SME 211 • Remote Communication and Control
– Busy
E22
– Privilege violation
E24
– Device not present
E25
– Maximum connections exceeded
E26
– Bad file name or file not found
E28
begins on page 66. Symbols used in the table
61