Attach Ductwork - Amana AKEF3070 Manual

2
ATTACH
DUCTWORK
To install ductwork around a wall
oven, see Installing with a Wall Oven
pamphlet.
Duct Locations
Cooktop can be vented vertically or horizontally.
• If vented horizontally vent air through left or
rear wall.
• If vented vertically, locate hole between floor
joists.
• Do not vent exhaust air into a wall, ceiling, or a
concealed space of a building.
Left
exhaust
Blower housing front
7 / "
7
8
Cooktop Side View
7 / "
7
8
Cooktop Front View
Rear
exhaust
Vent filler piece
4"
Front
6 / "
7
8
6 / "
1
2
B–3
C L
6"
2 / "
1
8
Duct Connection
• Blower exhaust faces towards rear wall from
factory.
• Blower can be changed to exhaust to left.
Refer to Duct Length Calculations for proper
duct length.
• To vent out left side, remove vent filler piece
and move to the rear of the blower.
• Connect blower exhaust to ducting with
3 1/4 x 10-inch piece.
• Do not install 2 elbow fittings next to each
other. This creates unusual air patterns and
can result in poor ventilation.
• Always vent outside. Do not vent into an attic or
crawl space.
• Seal all joints in venting system with duct tape
to avoid smoke or odor in home.
• Do not use laundry wall caps. Wall cap must
4"
have minimum of 28 square inches free air
space. Use Amana wall cap model CC30 or
equivalent.
C L
2 / "
3
4
8 / "
1
4
Back Edge of
Cooktop Cutout
RS2420004 Rev. 0