Table of Contents
Advertisement
Chapter 3
3.4.2 Create RAID
The following steps shall be taken to create RAID in BIOS.
1. Use the arrow key to select
2. Press
Enter
3. Select
1. Array Mode
4. Select the intended RAID level in the popup selection box and press
Enter.
5. Select
2. Select Disk Drives
Enter.
6. Select the disks to be used for creating the disk array and press
Enter
to confirm in the channel status zone.
7. Select
3. Start Creation Process
selection box you have selected
8. Press
Y
to continue when the warning message appears.
Note:
1. If you have selected
popup sub-interface after the operation of
direct go to
Process
. The default strip size is
2. Different warning messages appear according to different RAID levels.
1. Create
RAID.
to confirm and go to next.
in the popup sub-interface and press Enter.
in the previous sub-interface and press
and press
Stripping (RAID 0) for
Stripping (RAID 0) for Performance
3. Strip Size 64K
and then select
64K
.
3-33
RAID Setting Guide
Enter
except that in the
Performance.
in the
1. Array Mode
, you should
4. Start Creation
Advertisement
Table of Contents
