Controlling The Projector Through A Lan Environment - BenQ MP776 User Manual

Controlling the projector through a Lan Controlling the projector through a Lan
Controlling the projector through a Lan Controlling the projector through a Lan
environment environment
environment environment
Lan Control Settings allow you to manage the projector from a computer using a web Lan Control Settings
Lan Control Settings Lan Control Settings
browser when the computer and the projector are properly connected to the same local area
network.
Configuring the Lan Control Settings Configuring the Configuring the Configuring the
If you are in a DHCP environment: If you are in a DHCP environment: If you are in a DHCP environment: If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
2. Press MENU/EXIT
is highlighted.
3. Press
Settings page displays. Settings
Settings Settings
4. Press
5. Press
6. Press
7. Re-enter the Lan Control Settings
Default Gateway, and DNS Server Default Gateway Default Gateway Default Gateway
displayed in the Projector IP Address
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment: If you are in a non-DHCP environment: If you are in a non-DHCP environment: If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
3. Contact your ITS administrator for information on the Projector IP Address
Mask, Default Gateway Mask Mask Mask
4. Press
5. Press
6. To save the settings, press Mode/Enter
Menu/Exit. Menu/Exit Menu/Exit Menu/Exit
7. Press
40 Operation
Lan Control Settings Lan Control Settings Lan Control Settings
MENU/EXIT and then press
MENU/EXIT MENU/EXIT
to highlight Lan Control Settings Lan Control Settings and press MODE/ENTER
Lan Control Settings Lan Control Settings
to highlight Control By Control By and press
Control By Control By
to highlight DHCP DHCP and press
DHCP DHCP
to highlight Apply Apply Apply and press MODE/ENTER Apply
Lan Control Settings Lan Control Settings Lan Control Settings page. The Projector IP Address
DNS Server DNS Server settings will display. Note down the IP address DNS Server
Projector IP Address row. Projector IP Address Projector IP Address
to highlight DHCP DHCP DHCP DHCP and press
Default Gateway Default Gateway Default Gateway, and DNS Server
to select the item you want to modify and press Mode/Enter
/ to move the cursor and the press
Mode/Enter. If you do not want to save the settings, press Mode/Enter Mode/Enter
to highlight Apply Apply Apply Apply and press MODE/ENTER
/ until the SYSTEM SETUP: Advanced
/ to select RJ45
/ to select On
MODE/ENTER MODE/ENTER. MODE/ENTER
Projector IP Address, Subnet Mask Projector IP Address Projector IP Address
/ to select Off
DNS Server DNS Server settings. DNS Server
/
MODE/ENTER. MODE/ENTER MODE/ENTER
SYSTEM SETUP: Advanced menu
SYSTEM SETUP: Advanced SYSTEM SETUP: Advanced
MODE/ENTER. The Lan Control
MODE/ENTER MODE/ENTER
RJ45.
RJ45 RJ45
On.
On On
Subnet Mask Subnet Mask, Subnet Mask
Off. Off Off
Projector IP Address Projector IP Address, Subnet Projector IP Address
Mode/Enter.
Mode/Enter Mode/Enter
to enter the value.
Lan Control
Lan Control Lan Control
Subnet Subnet Subnet