Using The Access Point Mode - Belkin ME1004-R User Manual

Using the Web-Based Advanced User Interface

Using the Access Point Mode

Note:
This advanced feature should be employed by advanced users
only. The Router can be configured to work as a wireless network access
point. Using this mode will defeat the NAT IP sharing feature and DHCP
server. In Access Point (AP) mode, the Router will need to be configured
with an IP address that is in the same subnet as the rest of the network
that you will bridge to. The default IP address is 192.168.2.254 and
subnet mask is 255.255.255.0. These can be customized for your need.
1. Enable the AP mode my selecting "Enable" in the "Use as Access Point
only" page. When you select this option, you will be able to change the
IP settings.
2. Set your IP settings to match your network. Click "Apply Changes".
3. Connect a cable from the "Modem" port on the Router to your
existing network.
The Router is now acting as an access point. To access the Router's
Web-Based Advanced User Interface again, type the IP address you
specified into your browser's navigation bar. You can set the encryption
settings, MAC address filtering, SSID, and channel normally.
55
1
2
3
4
5
6
7
8
9
10