Ford MUSTANG MACH 1 2021 Supplement Manual page 57

E340110
A 19 in. x 9.5 in. front wheel, with
the valve hole in a smaller
window.
B 19 in. x 10 in. rear wheel, with the
valve hole in a larger window.
C 19 in. x 10.5 in. front wheel, with
the valve hole in a smaller
window.
D 19 in. x 11 in. rear wheel, with the
valve hole in a larger window.
Mustang (CZG) Mach 1, enUSA, First-Printing
Wheels and Tires
To make sure that your tires perform as
intended, it is important that you maintain
your tires properly:
•
•
•
•
•
•
•
•
54
Your original equipment tires are
optimized for performance in both wet
and dry conditions. We do not
recommend using the original
equipment tires when temperatures
drop to about 45°F (7°C) or below
(depending on tire wear and
environmental conditions) or in snow
and ice conditions.
The tires were designed for track use
and may exhibit significantly reduced
tread life and increased tire noise
compared to the standard equipment
tires under normal driving conditions.
Increasing the front camber settings
beyond the factory settings may further
accelerate tread wear and induce tire
noise.
For tire pressures, see the placard
located on the B-pillar inside the driver
door.
Always maintain your tire pressures
according to the tire information
placard on the driver door jamb, using
an accurate gauge.
Tire pressures are specified cold and
should be checked after the vehicle has
been parked for at least three hours.
Do not reduce pressure of warm tires.
Check your tire pressure often to
maintain it properly. Tire pressure can
diminish over time and fluctuate with
temperature.
Do not overload your vehicle.
Maximum vehicle and axle weights are
listed on the tire information placard.
Extra caution should be taken when
operating the vehicle near its maximum
load, including assuring proper tire
pressure and reducing speeds.