Table of Contents
Advertisement
Install the Access Point
Procedure
1. Keep the adapter to the center of the main mounting bracket, push and rotate it.
Figure 3: Flat metal easy-attach adapter being attached to the main mounting
bracket
2. Using the attachment holes on the easy-attach adapter, mark and drill two hole centers on a wall or
a solid flat ceiling.
3. Attach the easy-attach adapter to the wall using two Phillips pan-head screws.
Use screw-in anchors, if needed.
4. Connect the Ethernet cable RJ45 connector into the GE1 port.
5. Place the access point onto the bracket feet and slide it down to lock it in place.
Note
The bracket feet must be pointing up.
Install the Access Point Using the Main Mounting
Bracket and Easy-Attach Adapter
ExtremeWireless™ Access Points AP410i/e
19
Advertisement
Table of Contents
