Xerox Phaser 3052 Service Manual page 66

CN3
Snap Rings
& Washers
Figure 3 Feed and Registration Clutch / Feeder PWB
6. Remove the Feed and Registration Clutch Drive Gears
Figure 4 Feed and Registration Clutch Drive Gears
Repairs
REP 1.9
7.
Screw
Latches
(Figure 4).
Clutch Drive
Gears
8.
June 2014
4-14
Remove the following (Figure 5):
Make note of the order that the Feed and Registration Drive Gears are remove in so they
can be re-installed correctly.
a. Feed and Registration Drive Gears, there is a Snap Ring on one gear.
b. Feed and Registration Clutch Bushings (2 Snap Rings).
c. Exit Drive Gears, (2 screws and a Latch).
Exit Drive Gears
Feed & Registration Drive Gears
Figure 5 Drive Gears and Bushings
Remove the following from the Left Frame
a. Shaft Bushings (2), release the latches.
b. LSU Support (2 screws).
c. Paper Path Module (5 screws).
Snap Ring
Clutch Bushings
(Figure 6):
Xerox® Phaser® 3052/3260 Service Manual