Xerox Phaser 3052 Service Manual page 37

10-200/ 300 Fuser Under/ Over Temperature Fault
The temperature of the Fuser is outside of the normal operating range of 383°F ± 5°F (195°C ±
5°C.)
BSD-Reference: 10.1 Fuser
Initial Actions
Switch Off the power. Remove and reinstall the Fuser Assembly. Switch On the power.
Procedure
Do not handle the fuser components until they have cooled. Some fuser components
operate at hot temperatures and can produce serious personal injury if touched.
DANGER: Ne pas manipuler les éléments du four avant de les laisser refroidir. Certains
éléments du four fonctionnent à des températures très élevées et peuvent causer de
graves blessures s'ils sont touchés.
AVVERTENZA: Non maneggiare i componenti del fusore finché non sono raffreddati.
Alcuni di questi componenti funzionano ad alte temperature e possono provocare gravi
ferite se vengono toccati.
VORSICHT: Die Fixieranlage sollte erst gehandhabt werden, wenn diese genügend
abgekühlt ist. Einige Teile der Fixieranlage erzeugen übermäßige Hitze und führen bei
der Berührung zu schweren Verbrennungen.
AVISO: No manipule los componentes del fusor antes de que se enfríen. Algunos de los
componentes del fusor funcionan a altas temperaturas y pueden ocasionar daños per-
sonales graves si se los toca.
Enter Diagnostic (EDC) Mode. Select: [DC330 Test Routines, 109 Fuser Heat, Temp A] to
obtain a temperature reading from the Fuser. The Fuser temperature is within normal oper-
ating range.
Y N
Replace the Fuser Assembly (REP
If problem is intermittent, check the circuit of the Fuser Assembly for one of the following:
• All connectors are securely connected and no contamination is present.
• Short circuit or damaged wire. Repair as necessary.
Xerox® Phaser® 3052/3260 Service Manual
WARNING
1.17), PL 5.1.
17-100 IP Conflict Error Fault
The IP address conflicts with that of another system causing a machine communication error.
BSD-Reference: None
Procedure
Use Xerox Easy Print Manger to obtain a new IP address.
From the menu, select: [Advanced Settings, Machine Settings, Network Settings, Assign
IP address].
June 2014
2-15
Status Indicator RAPs
10-200/ 300 , 17-100