Alarm Mode - Grundig Discalo CCD 6300 Instructions Manual

32
___________________________________________
OPERATION
Deleting the track memory
Press »MEMORY« when the CD is in the stop position.
1
•
– The »
PROG.
Press » «.
2
STOP
7
•
– The »
PROG.
Note:
The track memory is also deleted,
– If the CD compartment is opened,
– If the sliding switch
device) is set to »MW«, »FM« or
– If you pull out the mains cable.

Alarm mode

Selecting the alarm times
Set the sliding switch
1
(left side of the device) to »ON«.
– Display: The »e1
or
Activate both alarm times by setting the sliding switches
ADJ« and »e2 OFF ON
– Display: The »e1
Displaying the alarm times
Set the sliding switch
1
(left side of the device) to »ADJ«.
– Display: the alarm time most recently set (1 or 2), flashes.
Note:
The sliding switches
(left side of the device) should not both be set to »ADJ«, as then the
alarm times cannot be displayed and also cannot be set.
Alarm with signal tone
Set the sliding switch
1
Set the sliding switch
2
(left side of the device) to »ON«.
– Display: The »e1
3 Press »ON/OFF« to switch the device to standby mode.
•
– The » « LED goes out.
ON
– The device switches on at the set alarm times with the alarm signal
(alarm duration 90 minutes).
« LED flashes.
« LED goes out.
»CD MW FM FM
»FM
»e1 OFF ON ADJ« or
• •
« or »e2 « LED glows;
ADJ« (left side of the device) to »ON«.
• •
« and »e2 « LEDs glow.
»e1 OFF ON ADJ« or
»e1 OFF ON ADJ« and
»BUZZER MUSIC« to »BUZZER«.
»e1 OFF ON ADJ« or
• •
« or »e2 « LED glows.
STEREO« (right side of the
STEREO«,
»e2 OFF ON
»e1 OFF ON
»e2 OFF ON
»e2 OFF ON
»e2 OFF ON
ADJ«
ADJ«
ADJ«
ADJ«