Alarm Mode; Radio Operation; Adjusting The Volume - Grundig Sonoclock 490 User Manual

OPERATION
Switching on and off
1
Press »RADIO
the device.
2
Press » « to switch off (stand-by)
the device.

Radio operation

For the best FM (VHF) reception, it is
sufficient to direct the wire antenna
accordingly.
Tuning radio stations
1 Find and tune the station using
»- TUNING

Adjusting the volume

1 Adjust the volume using
»+ VOLUME
Adjusting the brightness of
the display
1
Increase the brightness of the dis-
»- DIMMER
play with
2 Decrease the brightness of the dis-
»- DIMMER
play with
Note:
Your device is equipped with
7
an automatically adjusts for the
brightness of the display.
_____________________________________
ON« to switch on
+«.
-«.
+«.
+«.

Alarm mode

Selecting the alarm times
The alarm stand-by (» « or » « )
must be activated.
1 »AL 1 1+2
Push the
switch to »1« or »2«.
– Display: the
LED glows;
or
activate both alarm times by plac-
»AL 1 1+2
ing the
the »1+2« position.
– Display: the
LEDs glow.
Displaying the alarm times
Depending on the setting
»AL 2«) either alarm time 1 or alarm
time 2 is displayed.
1
Press »ALARM« and hold it
down.
– Display: the last alarm time set.
2
Release »ALARM« to end the dis-
play of the alarm time.
– Display: the current time.
Note:
If the »AL 1 1+2
7
switch is set to »1+2«, the alarm
times cannot be displayed.
2« sliding
1« or
»AL »AL
2« sliding in
1« and
»AL »AL
1« or
(»AL
2« sliding
ENGLISH 19
2«
2«