Operation - Grundig Discalo CCD 6300 Instructions Manual

28

OPERATION

General functions
Switching on and off
1 Press »ON/OFF« to switch on the device from standby mode.
•
– The » « LED glows.
ON
2 Press »ON/OFF« to switch the device to standby mode.
•
– The » « LED goes out.
ON
Selecting the input source
Select the input source with
1
the device).
Adjusting the volume
Adjust the volume with »
1
Listening with headphones
Connect the headphones to the »0« socket (ø 3.5 mm) (left side of the
1
device).
– This automatically switches off the loudspeakers.
Radio operation
For the best FM (VHF) reception, it is sufficient to direct the wire antenna.
The radio has a built-in rod antenna for MW reception. Turn the device aro-
und to direct the antenna.
Selecting the radio input source
Set the sliding switch
1
device) to »MW«, »FM« or
Tuning radio stations
Select the frequency band (FM or MW) with
1
STEREO« (right side of the device).
2 Set the desired radio station with »
Stereo/mono reception
If the sliding switch »CD MW FM FM
device) is set to »FM STEREO«, the device can receive FM stereo stations. If
this is the case, the »
FM STEREO
from the FM stereo station is weak, you can improve the sound quality by
switching to mono reception.
Use the sliding switch
1
device) to switch from
– The »
FM STEREO
Use the sliding switch
2
of the device) to switch from »FM« to
__________________________________________
»CD MW FM FM
|
VOLUME
»CD MW FM FM STEREO« (right side of the
»FM STEREO«.
TUNING
STEREO« (on the right side of the
•
« LED glows. However, if the signal
»CD MW FM FM STEREO« (right side of the
»FM STEREO« to »FM«, i.e. mono.
•
« LED goes out.
»CD MW FM FM STEREO« (on the right side
»FM STEREO«, i.e. stereo.
STEREO« (right side of
« (right side of the device).
»CD MW FM FM
« (right side of the device).