Advertisement
SCION
Procedure
Issue: A
04/15/04
tC
2005 -
Fig. 9-1
Fig. 9-2
Fig. 9-3
Fig. 9-4
Fig. 9-5
Page 9 of 17 pages
VSE SUBWOOFER (BAZOOKA
(e) Referencing Step 3. b, reassemble the rear
Cargo Floor panel & floor mat (if equipped).
(f) Referencing Step 3. a, reassemble the rear
Tonneau Cover.
(g) Referencing Step 3. e, reassemble the rear
bench seat.
9. Install VSE Subwoofer
(a) With the pigtail exiting the inner quarter
panels' taillight access hole, connect the
pigtail to the VSE Subwoofer. (Fig.9-1)
(b) Align the lower mounting stud through the
enclosures' lower hole, followed by the upper
mounting stud.
(1) Install the lower mounting assemblies' flat
washer & locknut onto the lower mounting
stud, tighten using 10mm socket. (Fig.9-2)
(c) Install the upper mounting assemblies' flat
washer (with EVA gasket facing quarter
panel) & lock nut onto the upper mounting
stud, & SECURELY tighten using a 13mm
ratcheting box end wrench. (Fig.9-2)
(d) Reinstall 10" driver into enclosure, by
connecting the 4 speaker connectors to the
driver (any sequence is acceptable). (Fig.9-3)
(1) Once connectors have been connected,
align the holes of the driver with the holes
of the enclosure, and fasten with the
supplied 8 Philips head screws. (Fig.9-4)
(e) Adjust the Gain Control knob to the factory
suggested position (indicated by the setting
dot). (Fig.9-5)
(f) NOTE: Only reinstall front grille after
completing Step 13 "Test & Set Up
Procedures"
®
)
Advertisement
