Advertisement
SCION
Procedure
FRONT WASHER
REAR WASHER
FRONT
LOCK
NUT
Issue: A
04/15/04
tC
2005 -
Fig. 5-5
Fig. 5-6
Fig. 5-7
Fig. 6-1
Fig. 7-1
REAR
LOCK
NUT
Fig. 7-2
Page 7 of 17 pages
VSE SUBWOOFER (BAZOOKA
(g) Attach wire harness with one (1) 4" wire tie at
the junction plug located underneath kick
well. (Fig.5-5)
(1) Using the diagonal cutter pliers, clip the
4" wire tie. (Fig.5-5)
(h) Route wire harness up behind the dash and
secure wire harness to the dash reinforcement
bar using (1) 7" wire tie.
(1) Using the diagonal cutter pliers, clip the 7"
wire tie. (Fig.5-6)
(i) Route remaining wire harness towards radio
opening and attach harness to the vertical dash
reinforcement using one (1) 4" wire tie.
(1) Using the diagonal cutter pliers, clip the 4"
wire tie. (Fig.5-7)
6. Prepare VSE Subwoofer for Installation
NOTE: ALL SUBWOOFER COMPONENTS
THAT ARE REMOVED MUST BE PLACED ON A
CLEAN & PROTECTED SURFACE (i.e. Blanket)
(a) Using a NRT, carefully remove the front
screen of the enclosure. (Fig.6-1)
(b) Remove the two (2) temporary shipping
Philips screws and discard.
(c) Carefully remove the 10" driver.
7. Modify Rear Inner Quarter Panel
(a) Prepare the upper hardware assembly by
removing the front lock nut & first front
washer (leaving the second front washer
installed). Then remove the back lock nut and
flat washer. (Fig.7-1)
(b) Install the hardware assembly through the
front side of the accommodation hole located
on the lower inner sheet metal panel; secure
the hardware assembly by fastening the back
®
)
Advertisement
