Advertisement
SCION
Procedure
Fig. 7-3
Fig. 7-4
Issue: A
04/15/04
tC
2005 -
Page 8 of 17 pages
VSE SUBWOOFER (BAZOOKA
flat washer and lock nut using a 13mm
ratcheting box end wrench or socket from
behind the inner sheet metal panel. (Fig.7-2)
(1) Make sure antenna wire harness runs
underneath hardware assembly (Fig.7-2)
(c) With the upper hardware assembly installed,
index the outer rear quarter panel by
positioning panel over the hardware stud and
use the 5/8" Hole Punch & Mallet to punch a
hole through the panel. (Fig.7-3)
(1) NOTE: Make sure that the rear wire
harness Pigtail is routed out through the
rear taillight access hole of the panel.
(d) Using a 10mm socket and the original D-Ring
bolt (Reference Step 3. j.), install the lower
hardware assembly over the panel onto the
original D-Ring location. (Fig.7-4)
8. Reassemble Rear Cabin Interior Components
(a) Referencing Step 3. k. - n., reassemble the rear
inner quarter panel, making sure that all
fasteners, clips, etc, are securely fastened.
(1) The front portion of the rear inner quarter
panel will need to hook into the inside of
the rear cargo passenger side inner panel
(2) NOTE: Make sure that the rear wire
harness Pigtail is routed out through the
rear taillight access hole of the panel.
(b) Referencing Step 3. f. - i., reassemble the rear
seat panel & two D-Rings, making sure that
all fasteners, clips, etc, are securely fastened
(c) Referencing Step 3. d, reassemble the rear
passenger side storage compartment.
(d) Referencing Step 3. c, reassemble the rear
cargo entry scuff plate.
®
)
Advertisement
