Download Print this page

Bazooka PTS20-21050 Installation Instructions Manual page 15

Vse subwoofer for scion

Advertisement

SCION
Troubleshooting.
Condition:
No sound from VSE Subwoofer, however
factory speakers still play
Distorted Sound
Low Sound
Rattling Noises
Issue: A
04/15/04
tC
2005 -
Page 15 of 17 pages
VSE SUBWOOFER (BAZOOKA
Check For:
1. Is the green L.E.D. lit on the VSE
Subwoofer? If not, check for 12 volts on pins
of the VSE Subwoofer with the ignition on.
If either pin doesn't indicate 12 volts, check
T-Harness connectors behind the radio.
2. Is the 14-pin Molex connector securely
connected to the VSE Subwoofer?
3. Is the ground ring securely fastened to the
rear anchorage bolt?
1. Close the back hatch of the vehicle
2. Adjust the radio to a comfortable listening
level, and then turn the "gain control" knob
on the VSE Subwoofer counter-clockwise
until the sound becomes clean.
1. Close the back hatch of the vehicle
2. Adjust the radio to a comfortable listening
level, and then turn the "gain control" knob
on the VSE Subwoofer clockwise until the
sound becomes audible. Do not adjust the
level too high, as this will result in distorted
sound.
Rattling will be evident in some panels at
extreme volume conditions, but make sure
you have performed the following to
minimize noise:
1. Securely tightened Mounting Hardware so
VSE Subwoofer does not move.
®
)

Advertisement

loading