Charging The Battery; Battery Life - VeriFone T650p Installation Manual

To install a paper roll
Charging the
Battery

Battery Life

WARNING
1
Hold both sides of the paper door, which is on the upper corner of the device
and open the paper door by pulling outside (See below Figure 10).
2
Remove any partial roll of paper in the tray.
Figure 10 Steps to Install a Paper Roll in the T650p
3
Loosen the glued leading edge of the new paper roll or remove the protective
strip. Unwind the paper roll past any glue residue.
4
Hold the roll so that paper feeds from the top of the roll.
5
Pull the paper past the printer door.
6
Align the printer paper to the tabs to the paper guides and hold the paper up
when closing the door.
7
With the printer paper extending outside, close the printer door by swinging
upward until the door clicks shut, allowing the printer paper to extend outside
the printer door.
After unpacking your T650p device, connect the power pack to the unit for eight
hours or until fully charged. Refer to the
Charging and discharging the battery will cause normal wear on the battery.
Li-Polymer and Li-Ion batteries must be recycled or disposed off
properly as per local guidelines/regulations.
Using the Battery section for more details.
T650
P
D S
EVICE ETUP

Charging the Battery

21
I G
NSTALLATION UIDE