To install a paper roll
Charging the
Battery
Battery Life
WARNING
1
Hold both sides of the paper door, which is on the upper corner of the device
and open the paper door by pulling outside (See
2
Remove any partial roll of paper in the tray.
Figure 10
Steps to Install a Paper Roll in the V660p-2
3
Loosen the glued leading edge of the new paper roll or remove the protective
strip. Unwind the paper roll past any glue residue.
4
Hold the roll so that paper feeds from the bottom of the roll.
5
Pull the paper past the printer door.
6
Align the printer paper to the tabs to the paper guides and hold the paper up
when closing the door.
7
With the printer paper extending outside, close the printer door by swinging
upward until the door clicks shut, allowing the printer paper to extend outside
the printer door.
After unpacking your V660p-2 devices, connect the power pack to the unit for
eight hours or until fully charged. Refer to the
details.
Charging and discharging the battery will cause normal wear on the battery.
Li-Polymer and Li-Ion batteries must be recycled or disposed of
properly as per local guidelines/regulations.
Charging the Battery
Figure
10).
Using the Battery
section for more
V660
-2 I
P
NSTALLATION
D
S
EVICE
ETUP
21
G
UIDE