Table of Contents
Advertisement
Loading/Saving Clips
You can load clips saved on an SD card, or import clips from a project.
You can also save clips to the SD card.
* You cannot load or save clips from/to the VOCAL track.
Loading from the SD Card
* Only clips whose track type matches the destination track's type can be
loaded.
1 .
Press the [SEQ] button to set the workflow to "Sequencer."
2 .
Press the [SECTION SELECT] button to switch the pads to
Section Select mode.
3 .
Press a button from [KICK] through [INST 2] to select a track.
4 .
Press the [EDIT] button, and then press pads [1]–[16] to select
where to load the clip.
The CLIP EDIT MENU screen appears.
5 .
Use the [VALUE] dial to select "LOAD CLIP," and then press the
[VALUE] dial.
The CLIP FILE screen appears.
6 .
Use the [VALUE] dial to select the clip that you want to load,
and then press the [VALUE] dial.
The clip is now loaded.
Importing from a Project
* Only clips whose track type matches the destination track's type can be
imported.
1 .
Press the [SEQ] button to set the workflow to "Sequencer."
2 .
Press the [SECTION SELECT] button to switch the pads to
Section Select mode.
3 .
Press a button from [KICK] through [INST 2] to select a track.
4 .
Press the [EDIT] button, and then press pads [1]–[16] to select
where to import the clip.
The CLIP EDIT MENU screen appears.
5 .
Use the [VALUE] dial to select "IMPORT CLIP," and then press
the [VALUE] dial.
The SELECT PROJECT screen appears.
6 .
Select the project file containing the clip that you want to
import, and then press the [VALUE] dial.
7 .
Use the [VALUE] dial to select the clip that you want to
import, and then press the [VALUE] dial.
The clip is imported.
Saving to an SD Card
1 .
Press the [SEQ] button to set the workflow to "Sequencer."
2 .
Press the [SECTION SELECT] button to switch the pads to
Section Select mode.
3 .
Press a button from [KICK] through [INST 2] to select a track.
4 .
Press the [EDIT] button, and then press pads [1]–[16] to select
the clip to save.
The CLIP EDIT MENU screen appears.
5 .
Use the [VALUE] dial to select "SAVE CLIP," and then press the
[VALUE] dial.
The edit screen for the clip name appears.
Cursor (blinking)
6 .
Give the clip a name.
You can change the character shown at the cursor position.
Operation
Explanation
MEASURE [<] [>]
Selects the character to edit.
[VALUE]
Edits the character.
[SHIFT] + MEASURE [>]
Inserts a space.
[SHIFT] + MEASURE [<]
Deletes the character.
[CLEAR]
Deletes the character and replaces it with a space.
7 .
Press the [VALUE] dial.
The clip is saved to the SD card.
* If there is already a clip with the same name, a confirmation message
appears, asking you whether to overwrite it and save the new clip. Select
"OK" to overwrite and save, or "Cancel" to stop.
21
Advertisement
Table of Contents
