Table of Contents
Advertisement
Installation: Rear Facing
Lap-Belt Installation
•
Figure A illustrates a typical rear-facing, lap-belt
installation.
•
When not in use, always store LATCH connectors in
storage slots. (See page 28).
WARNING!
Do not install with non-locking (ELR),
2-point vehicle belt.
1�
Fully recline restraint, then place it rear facing on
vehicle seat.
2�
Lift cover and open rear-facing lock-off farthest
from where vehicle belt will be buckled.
3�
Pull vehicle belt out, then pass it through farthest
rear-facing belt slot from where vehicle belt will
be buckled (fig. B).
•
The vehicle belt can be routed over or under restraint
cover.
4�
Route vehicle belt across seat, behind buckle strap,
then through second rear-facing belt slot.
5�
Verify vehicle belt is not twisted, then buckle (fig. C).
6�
Push child restraint firmly into vehicle seat while
removing slack from vehicle belt.
7�
Position vehicle belt through lock-off (fig. D),
tighten belt, close lock-off arm and replace cover.
•
Lock-off is properly closed when a click is heard.
•
To prevent breakage, never extend lock-off arm beyond
its natural open position and always keep lock-off closed
when not in use.
•
I
f your vehicle is equipped with an automatic locking retractor (ALR), use
of lock-offs is not required as long as ALR is activated. Check your vehicle's
owner's manual to determine type of retractor your vehicle has, and for proper
use of retractor.
16
A
B
C
Advertisement
Table of Contents
