Table of Contents
Advertisement
Installation: Forward Facing
Lap/Shoulder Belt Installation
•
Figure A illustrates a typical forward-facing lap/
shoulder-belt installation.
•
When not in use, always store LATCH connectors in
storage slots.
1�
Place child restraint forward facing on
vehicle seat.
•
Restraint can be used in recline position when
installed in forward-facing mode with children up
to 40 pounds (18 kg.).
•
Britax recommends use of Versa-Tether® to
improve installation. If using Versa-Tether
pages 23-26), locate tether on rear of restraint
and place up and over seat back while securing
restraint.
2�
Pull the vehicle belt out, then pass it through
both forward-facing belt slots (
3�
Verify that the vehicle belt is not twisted, then
buckle (
).
Fig. C
4�
Rotate the lock-off lever downward to open
(
).
Fig. D
•
Only use lock-off farthest from where the vehicle
belt is buckled.
5�
Push child restraint into the vehicle seat while
pulling the shoulder portion of the vehicle belt
tightly through the lock-off to remove slack.
20
(see
®
).
Fig. B
A
B
C
Advertisement
Table of Contents
