Table of Contents
Advertisement
Installation: Rear Facing
Lap/Shoulder Belt Installation
•
Figure A illustrates a typical rear-facing, lap/shoulder belt
installation.
•
When not in use, always store LATCH connectors in storage
slots. (see page 28).
1�
Fully recline restraint then place it rear facing on
vehicle seat.
2�
Lift cover to open rear-facing lock-off farthest from
where vehicle belt will be buckled.
3�
Pull vehicle belt out then pass it through farthest
rear-facing belt slot from where vehicle belt will be
buckled (fig. B).
•
Vehicle belt can be routed over or under cover.
4�
Route vehicle belt across seat, behind buckle strap,
then through second rear-facing belt slot.
5�
Verify vehicle belt is not twisted, then buckle
(fig. C).
6�
Push restraint firmly into seat while removing
slack first from the lap portion of vehicle belt, then
shoulder portion (fig. D).
7�
Lift cover to access lock-off farthest from vehicle
buckle. Position both sections of vehicle belt
through lock-off, tighten belt, close lock-off arm
(fig. E) and replace cover.
•
Lock-off is properly closed when a click is heard.
•
To prevent breakage, never extend lock-off arm beyond its
natural open position and always keep lock-off closed when
not in use.
•
If your vehicle is equipped with an automatic locking
retractor (ALR), use of lock-offs is not required as long as
ALR is activated. Check your vehicle's owner's manual to
determine type of retractor your vehicle has, and for proper
use of retractor.
14
A
B
C
D
Advertisement
Table of Contents
