Initial Setup; Ø Unpacking; Ø Components; Motor Switch - Banner American Easy-Lam II Operating Instructions Manual

Unpacking
Before unpacking the unit, inspect the shipping container for signs of
damage. Notify the carrier and your dealer immediately if any damage is
noted.
CAUTION! The laminator weighs approximately 91 lbs. Use two
people when removing the laminator from the shipping container.
NOTE! We recommend saving the packaging in case you have to
return the unit.
Components
Figure 1 shows the location of the major components and controls of the
Easy-Lam II. You should become familiar with these before operating the
laminator.

Motor Switch

This switch provides power to the motor. If the switch is pressed to
the "on" position, the rollers move the plastic film and laminating
material through the unit.

Reverse Switch

This toggle switch is found on the back of the machine. When this
switch is pressed to the "REV" (upper) position, and the motor switch
is on, the rollers move in the reverse direction. This is useful for
clearing film from the rollers.

INITIAL SETUP

6