Banner American Easy-Lam II Operating Instructions Manual page 16

ACTION:
PROBLEM:
ACTION:
PROBLEM:
ACTION:
PROBLEM:
ACTION:
PROBLEM:
ACTION:
Check the thickness of item to be laminated. Maximum
thickness is 1/16" (1.6mm).
Clean heat shoes of residual adhesive. Refer to the
MAINTENANCE section for cleaning instructions.
Plastic is not bonding to the item or to itself at the edges.
Make sure heat shoes and rollers are at the proper
operating temperature and have had time to warm up.
Wrinkles appear on the laminated items running parallel
with the outside edges.
Increase roller tension on top and/or bottom supply rolls.
Reduce heat shoe temperature.
Clean heat shoes of residual adhesive. See
MAINTENANCE section for cleaning instructions.
Blistering of the film appears over the item or along the
edge.
Reduce the temperature on the heat shoes. If the red heat
indicator light remains on after this adjustment is made,
disconnect the power supply and contact your dealer.
Clean laminating rollers. See MAINTENANCE section
for cleaning instructions.
Laminated material curls after leaving pull rollers.
Adjust tension. If laminated item curls upwards, reduce
top roller tension. If item curls downward, reduce
bottom roller tension.
Clean heat shoes of residual adhesive as this may cause
"drag" on one side. Refer to MAINTENANCE section
for cleaning instructions.
16