Kohler Intelligent Toilet Homeowner's Manual page 7

Remote Control - Cleansing Features
IMPORTANT! To activate features using the remote control, the remote must be paired with the toilet.
Refer to the "Remote Control - Setup" section.
NOTE: Water temperature, water pressure, wand position, and massage action are adjustable while the
front or rear wash is in use. The dots to the left of the icons indicate the current setting.
Front Wash - Press the "front" icon to activate water spray from the front of the wand. Washing will
stop automatically after 5 minutes or can be stopped by pressing the "stop" icon.
Rear Wash - Press the "rear" icon to activate water spray from the back of the wand. Washing will
stop automatically after 5 minutes or can be stopped by pressing the "stop" icon.
Massage - Press the "massage" icon to activate oscillating action. Press again to switch to pulsating
action. Press a third time for simultaneous oscillating and pulsating actions. Press a fourth time to
stop the action.
Spiral - Press the "spiral" icon to activate spiral action. This feature is only available while the rear
wash is in use. Press the icon again to stop the action.
Water Temperature - Press the "water temp" icon, then press the "+" or "–" icon to increase or
decrease the temperature through five settings.
Water Pressure - Press the "pressure" icon, then press the "+" or "–" icon to increase or decrease
water pressure through five settings.
Wand Position - Press the "position" icon, then press the "+" or "–" icon to adjust the wand position
through five settings.
Kohler Co. 7 1295780-5-A