Install DS1 Connections
For the DS1 Connections, refer to
steps:
1. Route the wires through the same cable entry as the POTS cables.
2. Strip back the jacket of a CAT 5 or 6 cable.
3. Connect the wires to the RJ-45 connectors using a RJ-45 crimper.
4. Insert the RJ-45 connectors in the appropriate DS1 socket.
Refer to
DS1 RJ-45 Pin-out
Pin
1
2
3
4
5
7–8
61287723G1-5B
Table 8
for a list of DS1 Cable Pin-Outs.
Table 8. DS1 Cable Pin-Outs
Name
Rx Data (Ring)
Rx Data (Tip)
–
Tx Data (Ring)
Tx Data (Tip)
–
Figure 14
on page 27 and
Description
From customer to Network Interface
From customer to Network Interface
Not Used
From Network Interface to customer
From Network Interface to customer
Not Used
Table 8
to complete the following
Installation
29