Modules And Housings; Safety And Regulatory Compliance; Table 3. Modules And Housings - ADTRAN Total Access 372E Installation And Maintenance Manual

Modules and Housings

This manual covers the following electronic modules and housings:
NOTE
The Total Access 372E SBU ONT is only intended to be used with the Corning
Systems Model FNI-NG series outdoor NID housing.

Safety and Regulatory Compliance

!
WARNING
• The 10/100/1000Base-T port(s) and POTS are classified as Type 4 as
defined in Appendix B of GR-1089-CORE, Issue 4, and is suitable for
connection to intra-building or unexposed wiring or cabling only. Do not
metallically connect these ports to interfaces which connect to the Outside
Plant (OSP) or to the OSP wiring. The 10/100/1000Base-T ports and POTS
are designed for use as an intra-building interface only (Type 4 ports as
described in GR-1089-CORE, Issue 4) and require isolation from exposed
OSP cabling. The addition of Primary Protectors is not sufficient protection
in order to connect this interface metallically to OSP wiring.
• The DS1 port(s) are classified as Type 3, 4 or 5, as defined in Appendix B of
GR-1089-CORE Issue 5. If deployed as type 3, or 5 the ports meet the
lightning and power fault criteria with any primary protector that meets
any of the voltage limits of GR-974- CORE or GR-1361-CORE (that is,
carbon blocks, gas tubes, and so forth). If deployed as Type 4 primary
protectors are not required.
61287723G1-5B
Total Access 372E
1287723G1
1187774G1
1187775G1

Table 3. Modules and Housings

Description
Total Access 372E SBU Electronics Module
Standard SBU Housing
SBU OptiTap Housing
Safety and Regulatory Compliance
3