Install Ethernet Connections; Figure 14. Ethernet And Ds1 Cable Connections - ADTRAN Total Access 372E Installation And Maintenance Manual

Install Ethernet Connections

The SBU ONT supports two Gigabit Ethernet ports. The cable used should be rated CAT 5 or
6. For Ethernet connections refer to
1. Route the Subscriber Ethernet wires through the same cable entry as the POTS cables.
2. Strip back the jacket of a CAT 5 or 6 cable and connect the 4 pair twisted wires to the RJ-
3. Insert the terminated RJ-45 jack into the appropriate ETHERNET 1–2 socket on the SBU
61287723G1-5B
45 Plug using a RJ-45 crimper.
ONT.

Figure 14. Ethernet and DS1 Cable Connections

Figure 14 and Table 6 to complete the following steps:
TOTAL ACCESS 372
1287722G1
TELEPHONE TROUBLESHOOTING:
1. Identify the bad line (POTS 1-8).
2. Plug any working phone into
the appropriate jack.
If the telephone works, the unit
is functioning normally.
If the telephone does not work,
contact your service provider.
3. Remove the telephone from the
POTS jack.
DS1
Connection (Red)
Ethernet
Connection (White)
Installation
27