After Finishing Work; When Work Is Finished; Transporting; Transporting The Pole Pruner - Stihl HTA 66 Instruction Manual

12 After Finishing Work

2
► If the limb is under tension: Make the relieving cut (1) at
the compression side and then perform the bucking cut (2)
from the tension side.
Cutting thick branches
1
► Perform a relieving cut (2) at cutting point (2) at a distance
a = 20 cm from the final cross cut (1).
► Perform a relieving cut and then finish with a cross-cut (1).
12 After Finishing Work

12.1 When Work is Finished

► Switch off the pole pruner and remove the battery.
► If the pole pruner is wet: Allow the pole pruner to dry.
► If the battery is wet: Allow the battery to dry.
0458-191-9621-A
1
a
2
► Clean the pole pruner.
► Clean the guide bar and saw chain.
► Loosen the nut on the chain sprocket cover.
► Back off the tensioning screw 2 turns counterclockwise.
The saw chain is now slack.
► Tighten down the nut on the chain sprocket cover.
► Fit the chain scabbard so that it completely covers the
guide bar.
► Clean the battery.

13 Transporting

13.1 Transporting the Pole Pruner

► Switch off the pole pruner and remove the battery.
► Fit the chain scabbard so that it completely covers the
guide bar.
► Push in shaft completely (HTA 86).
Carrying the pole pruner
► Carry the pole pruner in one hand by the shaft with the
guide bar behind you.
Transporting the pole pruner in the car
► Secure the pole pruner to prevent turnover and
movement.

13.2 Transporting the battery

► Switch off the pole pruner and remove the battery.
► Check that the battery is in a safe condition.
► Pack the battery so that the following points apply:
– The packaging is electrically non-conductive.
– The battery cannot move inside the packaging.
► Secure the packaging so that it cannot move.
English
65